Measurement-computing Micro 488/EX rev.2.1 Uživatelský manuál Strana 25

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 218
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 24
Section 2 Getting Started
2.11
SW2 View for Mode Selection
OPEN
12345678
DOT
Switch
Side
View
System Controller
OPEN
12345678
Peripheral
OPEN
12345678
Controller Pass-Thru
OPEN
12345678
Peripheral Pass-Thru
2.6 IEEE Address Selection
SW3-1 through SW3-5 select the IEEE bus address of the Micro488/EX when in
the System Controller, Peripheral and Peripheral Pass-Thru modes. These same
switches are used in the Controller Pass-Thru mode to select the address of the device
that will be controlled. [Refer to Section 6 for additional information]. The address is
selected by simple binary weighting with SW3-1 being the least significant bit and
SW3-5 the most significant. The factory default is address 10.
Zobrazit stránku 24
1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 217 218

Komentáře k této Příručce

Žádné komentáře