Measurement-computing DBK Part 2 Uživatelský manuál Strana 293

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 306
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 292
Connection Tips
CAUTION
Turn off power to the host PC and externally connected equipment prior to connecting
cables or signal lines to DBKs. Electric shock or damage to equipment can result even
under low-voltage conditions.
Take ESD precautions (packaging, proper handling, grounded wrist strap, etc.)
Use care to avoid touching board surfaces and onboard components. Only handle
boards by their edges (or ORBs, if applicable). Ensure boards do not come into
contact with foreign elements such as oils, water, and industrial particulate.
1. Ensure power is removed from all device(s) to be connected.
2. As soon as the DBK215 cover is removed, verify that the Host
Power LED is “Off.” See figure at right for location.
3. Observe ESD precautions when handling the board and making
connections.
4. You do not need to remove the cover unless you need to
access a terminal block, customize an RC filter network,
or set a BNC channel to Single-Ended mode or to Differential
mode (via Jumpers J0 through J7). Information regarding these
tasks follows shortly.
Location of DBK215’s
Host Power LED
5. DBK215’s 68-pin SCSI (P5) connector typically connects to a DaqBoard/500, /1000, or
/3000USB Series board via a CA-G55, CA-G56, or CA-G56-6 cable.
o CA-G55 is a 3-foot long cable.
o CA-G56 is a 3-foot long shielded cable.
o CA-G56-6 is a 6-foot long shielded cable.
6. Refer to the separate CE Cable Kit instructions that are included with the associated CE cable
kit. Refer to the Declaration of Conformity in regard to meeting CE requirements.
DBK Option Cards and Modules 897994 DBK215 pg. 3
Zobrazit stránku 292
1 2 ... 288 289 290 291 292 293 294 295 296 297 298 ... 305 306

Komentáře k této Příručce

Žádné komentáře