Measurement-computing WaveBook rev.5.3 Uživatelský manuál Strana 65
- Strana / 154
- Tabulka s obsahem
- ŘEŠENÍ PROBLÉMŮ
- KNIHY
Hodnocené. / 5. Na základě hodnocení zákazníků
Example 3: WaveBook/516A System with a WBK25, WBK17, and a WBK10A
Device Interface Side Channel Input Side
WaveBook/516A System
with a WBK25, WBK17, and a WBK10A
WBK10A
WBK17
WaveBook/516A
WBK25
Power
Power
Ethernet
Lines and Cables Used in Example 3, excluding channel input connections.
1. Power Supply - To the WaveBook/516A POWER IN DIN 5 connector, +10 VDC to +30 VDC,
typically from a TR-40U power adapter.
2. Power Supply – From the WaveBook/516A’s POWER OUT DIN 5 connector to the WBK25’s
POWER IN DIN 5 connector via a CA-115 Power Cable.
3. Power Supply - To the WBK17’s POWER IN DIN 5 connector, +10 VDC to +30 VDC, typically
from a TR-40U power adapter.
4. Power Supply – From the WBK17’s POWER OUT DIN 5 connector, +10 VDC to +30 VDC, to the
WBK10A’s POWER IN DIN 5 connector via a CA-115 Power Cable.
5. Ethernet – From the WBK25’s ETHERNET jack to a 10/100BaseT Ethernet Network or to the
ETHERNET jack on a PC. Applicable Ethernet patch cables (1.5-foot or 7-foot) are CA-242 and
CA-242-7, respectively.
6. Expansion – From the WBK25’s EXPANSION PORT 1 to the WaveBook/516A’s PARALLEL
PORT connector. The connection is made via a 25-pin CA-35-12 cable.
7. Expansion Control – From WaveBook/516A’s EXPANSION CONTROL to the WBK17’s
EXPANSION CONTROL IN. Connection is via a 15-pin CA-129 cable.
8. Expansion Control – From the WBK17’s EXPANSION CONTROL OUT to the WBK10A’s
EXPANSION CONTROL IN. Connection is via a 15-pin CA-129 cable.
9. Expansion Signal – From the WBK10A’s EXPANSION SIGNAL OUT to the WBK17’s
EXPANSION SIGNAL IN. Connection is via a BNC coaxial CA-150 cable.
10. Expansion Signal – From the WBK17’s EXPANSION SIGNAL OUT to the WaveBook/516A’s
EXPANSION SIGNAL IN. Connection is via a BNC coaxial CA-150 cable.
11. Digital Expansion – This connection is made on the channel input side of the units. The cable runs
from the WaveBook/516A’s DIGITAL I/O / EXTERNAL CLOCK / TTL TRIGGER connector to
the WBK17’s IN-DIGITAL EXPANSION connector (HD26 type). The connection is made via a
CA-217 Digital Expansion Cable.
WaveBook User’s Manual 897895 System Examples 3-5
- WaveBook 1
- About WaveBook Documentation 5
- Table of Contents 7
- Chapter 3 – System Examples 7
- Step 1 - Install Software 9
- *324604B-01* 10
- Before you get started 11
- *324605B-01* 12
- What Are WaveBooks? 13
- WaveBook Product Comparison 14
- What Are WBKs? 15
- Minimum Requirements 21
- WaveBook/516E Front Panel 22
- WaveBook/516E Rear Panel 22
- WaveBook/516A 25
- Parallel Port Connections 26
- Ethernet Connections 28
- CAUTION 29
- Install the Software 29
- For DEDICATED Networks 39
- Adding WBK Option Cards 41
- Adding WBK Modules 43
- DIN 5 Power Pinout* 44
- The Daisy-Chain Concept 46
- Scan Synchronization 47
- System Power, Examples 51
- Power Supplies 52
- 14 VDC Mode (default) 53
- 28 VDC Mode 53
- Hardware Setup 53
- Charging 54
- Environmental Concerns 58
- Fuse Replacement 59
- Introduction 61
- Cable Review 62
- WaveBook Fan 71
- Basic Operation 72
- WaveBook/516E Block Diagram 73
- Digital I/O Connections 83
- 8-Bit Mode 84
- Triggers 85
- Multi-Channel Trigger 86
- Trigger Level 88
- Trigger Latency & Jitter 89
- Pulse Trigger 90
- Digital-Pattern Trigger 91
- Note: The Clock Divider 92
- PDF NOTE: 93
- SYNC Notes: 94
- Programmable Features 95
- Selecting a Channel’s Units 96
- (b) for the application in 97
- WaveView_WaveCal.pdf 99
- PostAcquisition Analysis.pdf 99
- ProgrammersManual.pdf 99
- WaveView Out-of-the-Box 100
- Software 100
- Calibration Software 104
- Overview 105
- CE Standards and Directives 105
- Safety Conditions 106
- Shielded 107
- BNC Connector 107
- Dust Cap 107
- Noise Considerations 108
- Product Care 109
- Driver Support 110
- Troubleshooting Tables 111
- Channel readings are wrong 115
- WaveView Scope stops 116
- Ethernet Problems 119
- Parallel Port Problems 122
- – continued 124
- (continued) 124
- Frequently Asked Questions 126
- (5) Topic: ECP and EPP 128
- (6) Topic: Sampling Rates 128
- (7) Topic: Calibration 129
- Customer Support 130
- Specifications 8 131
- (Note 2) 133
- General Information 137
- WaveBook/516E 139
- 9-4 Fuse Replacement 140
- WaveBook User’s Manual 140
- 897495 Appendix A 142
- Before you run a test 147
- 927096 Appendix B 148
- Glossary 151
- 969597 Data Acquisition 152
Související produkty a manuály pro Hardware Measurement-computing WaveBook rev.5.3
(108 stránky)© 2020, manymanuals.cz. Všechna práva vyhrazena. | 0.116 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentáře k této Příručce