Measurement-computing Personal488 rev.3.0 Uživatelský manuál Strana 29

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 150
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 28
Windows Me
Personal488 for Windows 95/98/Me/NT/2000
04-06-01
Installation 3-19
Hardware Installation for Windows Me Users
Plug-and-Play Devices
Personal488/PCI
Personal488/ATpnp
Personal488/Card
1.
If you have not already done so, shutdown Windows Me after the IEEE 488 software has been
successfully installed.
2.
Remove power from the PC.
3.
Physically install your interface. As a quick reference,
Personal488/PCI installs into a 32-bit PCI expansion slot,
Personal488/ATpnp installs into a 16-bit ISA expansion slot, and
Personal488/Card installs into a PC card slot.
4.
Return power to the PC. After the computer powers up, Windows Me will detect your new hardware.
This completes the installation procedure.
Non plug-and-play Devices
Personal488/AT (AT488)
Personal488 (GP488B)
Personal488/MM
1.
If you have not already done so, shutdown Windows Me after the IEEE 488 software has been
successfully installed.
2.
Remove power from the PC.
3.
Physically configure the devices jumpers and switches to match the resource settings Windows Me
reported during the driver installation.
Non plug-and-play board users: physically configure your boards jumpers and switches
to match the resource settings Windows reported. If these settings conflict with other
hardware change the jumpers, switches, and Windows Resource settings to available
resources.
Reference Note:
Refer to Chapter 4, Hardware Configuration Reference for further information concerning
jumpers and switches.
4.
Return power to the PC.
This completes the installation procedure.
Zobrazit stránku 28
1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 149 150

Komentáře k této Příručce

Žádné komentáře