Measurement-computing eZ-NDT version 6.0.9 Uživatelský manuál Strana 27

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 48
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 26
eZ-NDT 878493 Windows and Menus 4-7
Modifying Limits from the Main Window
Add Limit Band: Using your mouse, right click on a Limit Range cell. Check “enabled,” then click the
<Apply> button.
Remove Limit Band: Using your mouse, right click on a Limit Range cell. Un-check “enabled,” then
click the <Apply> button.
Moving the Limit Band: To move a limit band, first unlock the Graphic Limits with the padlock icon
button; then select the desired Limit Range cell. Using your mouse, right-click anywhere within the band.
At this point you’ll see a crosshair. While pressing the right mouse-button, move the crosshair to the new
x-axis position. The Limit Band will relocate.
Changing the High and Low Frequency Range Limits: First unlock the Graphic Limits with the
padlock icon button; then select the desired Limit Range cell. Next place the mouse cursor of the vertical
line of the High or Low range limit. “HFR” or “LFRwill appear in a box (see preceding figure). Use the
double-arrow to adjust the limit. Note that you can also use the properties box to adjust the range limits, as
discussed on the previous page.
Adjusting the Low Frequency Range Limit
Other limit modifications include increasing or decreasing
Limit Band Frequency
Limit Band Amplitude
Adjustment of the Limit Band Frequency and Amplitude is discussed and illustrated in chapter 2, in the
section titled, 13. Verify the Limits and Ranges.
Magnifying Areas on Graph
X-axis: Hold down the <Ctrl> key, then left-click and drag the cursor lines across the area of interest.
Y-axis: Hold down the <Alt> key, then left-click and drag the cursor lines across the area of interest.
Both axes: At the same time, hold down the <Ctrl> and <Alt> keys while you draw a cursor box around
the area of interest.
In each of the above cases the x and y axis scales will automatically change to reflect the new view. Click
the <Auto Scale> button in the Display Toolbar to zoom back out to a full view.
Zobrazit stránku 26
1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 47 48

Komentáře k této Příručce

Žádné komentáře