Measurement-computing DataShuttle Uživatelský manuál stáhnout pdf (Strana 45)

DataShuttle and DynaRes

11-09-01

Installing the DynaRes 4-5

Determine which is to be the First Board. (This is easy, if it is the sole board.) Then turn its dial to 1.

Determine which is to be the Second Board, then set its switch to 2.

Continue to set the switches for all boards in your installation to unique numerical values in an unbroken

sequence.

(As various models of our boards use different kinds of switches, please see their owner’s manuals for an

explanation of how to set switches on other boards.)

Setting the Base Address

The Base Address determines the logical system address where the personal computer expects to find all

data acquisition boards. Base Addresses must be the same on all boards.

The factory setting for all of our data acquisition products is 300H (in hexadecimal format).

It is rarely necessary, but if you have difficulty getting the board to work, you can change these switches to

values different from the factory settings. (Another device in your PC, for example, might be trying to use

the same Base Address.)

Indications of this are: if the program reports it cannot find your board, or if it reports fewer boards than

you really have, or if another board starts to work improperly after you install the DynaRes.

These problems indicate interference with another board using the same base address as the DynaRes

product.

Remedy the problem by changing the switches of all data acquisition boards to an address that has no

conflict. (If you have boards other than DynaRes in your system, please refer to their owner’ s manuals for

instructions on how to change their settings.)

Setting DynaRes Base Address

To Set the Base Address

1. Locate the Address Switches Remove the cover of your computer over the data acquisition board, and

find the location of the Base Address switches. Refer to the board illustration on page 4 – 2 in this chapter

and find “Base Address Switches” on the DynaRes diagram.

On the printed circuit board itself, this is a block of four DIP switches.

Note: Depending on the space available in your installation, it might be necessary to remove the board to

reach the Base Address Switches. If so, please follow the same precautions as in “Physical

Installation” on page 4 – 3.)

2. Change the Setting 300H is the normal base address. It consists of all four DIP switches’ being in the

“up” position (when the board is sitting in the computer’s expansion slot).

The DIP switches have the labels “1” through “4.” Sliding a switch to the “down” position adds a value to

300H:

DynaRes Base Address Switch Additive Values*

Switch Position To 300H Add

1 Down 10H

2 Down 20H

3 Down 40H

4 Down 80H

* As the switches are additive, your sliding Switches 1 and 4 down, for example, is going to add 10H and

80H to the 300H, equalling 390H.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 125 126

Komentáře k této Příručce

Žádné komentáře

Measurement-computing DataShuttle Uživatelský manuál Strana 45

Komentáře k této Příručce

Související produkty a manuály pro Hardware Measurement-computing DataShuttle