Measurement-computing WEB-TEMP Uživatelský manuál stáhnout pdf (Strana 15)

Chapter 3

Signal Connections

Screw terminal pinout

The WEB-TEMP has four rows of screw terminals. There are 26 connections on each side. Signals are

identified in Figure 2.

Figure 2. Screw terminal pinout

Do not make connections to the terminals labeled NC. Use 16 AWG to 30 AWG wire for your signal

connections.

Tighten screw terminal connections

When making connections to the screw terminals, be sure to tighten the screw until tight. Simply touching the

top of the screw terminal is not sufficient to make a proper connection.

Sensor inputs

The WEB-TEMP supports the following temperature sensor types:

 Thermocouple – types J, K, R, S, T, N, E, and B

 Resistance temperature detectors (RTDs) – 2, 3, or 4-wire measurement modes of 100 Ω platinum RTDs.

 Thermistors – 2, 3, or 4-wire measurement modes.

 Semiconductor temperature sensors – LM35, TMP35 or equivalent

Sensor selection

The type of sensor you select will depend on your application needs. Review the temperature ranges and

accuracies of each sensor type to determine which is best suited for your application.

You can connect up to eight temperature sensors to the differential sensor inputs (C0H/C0L to C7H/C7L).

Supported sensor categories include thermocouples, RTDs, thermistors, or semiconductor sensors.

Do not mix sensor categories within channel pairs. You can, however, mix thermocouple types (J, K, R, S, T, N,

E, and B) within channel pairs.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 39 40

Žádné komentáře

Measurement-computing WEB-TEMP Uživatelský manuál Strana 15