Measurement-computing USB-ERB08 Uživatelský manuál stáhnout pdf (Strana 19)

Chapter 4

Specifications

Typical for 25 °C unless otherwise specified.

Specifications in italic text are guaranteed by design.

Output specifications

Table 1. Output specifications

Number of relays 8

Relay configuration 2 banks of 4

Contact configuration

8 Form C (SPDT) Normally Open, Normally Closed and Common available at

screw terminals

Contact rating 6 A @ 240 VAC or 28 VDC resistive

Contact resistance 100 milliohms max (initial value)

Operate time 10 milliseconds max

Release time 5 milliseconds max

Vibration 10 to 55 Hz (amplitude 1.5 mm)

Shock 10 G (11 milliseconds)

Dielectric isolation (between relay

open contact)

300 VAC, 50/60 Hz (1 minute)

Dielectric isolation (between PCB

output lines)

500VAC, 50/60 Hz (1 minute)

Life expectancy 10 million mechanical operations, min

S2 = pull-up Energized. NO in contact with Common Power on state

S2 = pull-down Not energized. NC in contact to Common

Relay control logic polarity

User-configurable per bank via switch S1 for invert or non-invert (default).

Switch settings for polarity can be read back via software through the USB bus.

Switch settings do not affect the power on condition. Non-invert mode: when "0"

is written or read back via the USB bus, relays are not energized. Invert mode:

when "0" is written or read back via the USB bus, relays are energized.

Pull-up / pull-down (controls relay

power on state)

User-configurable per bank via switch S2 for pull-down (default) or pull-up.

Switch settings can be read back via software. Pull-down will put the relays in

non-energized mode on power up. Pull-up will put the relays in energized mode

on power up.

Power

Table 2. Power specifications

Parameter Conditions Specification

USB +5 V input voltage range 4.75 V min. to 5.25 V max.

USB +5 V supply current All modes of operation 10 mA max

External power supply (required) MCC p/n CB-PWR-9 9 V ±10% @ 1 A

ext

< 6.0 V

ext

> 12.5 V PWR LED = Off (power fault) Voltage supervisor limits - PWR LED

6.0 V < V

ext

< 12.5 V PWR LED = On

All relays on, 100 mA downstream hub power 750 mA typ, 850 mA max

External power consumption

All relays off, 100 mA downstream hub power 170 mA typ, 200 mA max

4-1

1 2 ... 14 15 16 17 18 19 20 21 22 23

Komentáře k této Příručce

Žádné komentáře

Measurement-computing USB-ERB08 Uživatelský manuál Strana 19

Komentáře k této Příručce

Související produkty a manuály pro Hardware Measurement-computing USB-ERB08