Measurement-computing CIO-DAS1401/12 Uživatelský manuál stáhnout pdf (Strana 12)

CIO-DAS1401/12User's Guide Installing the CIO-DAS1401/12

Falling edge A/D trigger

DAS-1600 method

Rising edge A/D trigger

DAS-16 method

Default setting

Figure 6. Pacer edge jumper

The CIO-DAS1401/12 is shipped with the jumper in the rising (leading) edge position. Figure 6 shows the edge

selection options. For compatibility with all third party packages, with all DAS-16 software and with CIO-

DAS1401/12 software, leave this jumper in the rising edge position.

Installing the CIO-DAS1401/12

After you configure the board's switches and jumpers, you can install the CIO-DAS1401/12 into your

computer. To install your board, follow the steps below.

Install the MCC DAQ software before you install your board

The driver needed to run your board is installed with the MCC DAQ software. Therefore, you need to install

the MCC DAQ software before you install your board. Refer to the Quick Start Guide for instructions on

installing the software.

1. Turn your computer off, open it up, and insert your board into an available ISA slot.

2. Close your computer and turn it on.

3. To test your installation and configure your board, run the InstaCal utility you installed in the previous

section. Refer to the Quick Start Guide that came with your board www.mccdaq.com/PDFmanuals/DAQ-

Software-Quick-Start.pdf for information on how to initially set up and load InstaCal.

Connecting the board for I/O operations

Connectors, cables – main I/O connector

The table below lists the board connector, applicable cables, and compatible accessory products.

Board connector, cables, and accessory equipment

Connector type

37-pin D type connector

Compatible cable

C37FF-x

Compatible accessory products with

the C37FF-x cable

CIO-MINI37

CIO-SSH-16

Information on signal connections

General information regarding signal connection and configuration is available in the Guide to Signal

Connections (available at www.mccdaq.com/signals/signals.pdf).

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19

Žádné komentáře

Measurement-computing CIO-DAS1401/12 Uživatelský manuál Strana 12