Measurement-computing PCI-CTR10 Uživatelský manuál Strana 10
- Strana / 19
- Tabulka s obsahem
- KNIHY
Hodnocené. / 5. Na základě hodnocení zákazníků
PCI-CTR10 User's Guide Installing the PCI-CTR10
Unpacking the PCI-CTR10
As with any electronic device, you should take care while handling to avoid damage from static
electricity. Before removing the PCI-CTR10 from its packaging, ground yourself using a wrist strap or by
simply touching the computer chassis or other grounded object to eliminate any stored static charge.
If any components are missing or damaged, notify Measurement Computing Corporation immediately by
phone, fax, or e-mail:
! Phone: 508-946-5100 and follow the instructions for reaching Tech Support.
! Fax: 508-946-9500 to the attention of Tech Support
! Email: [email protected]
Installing the software
Refer to the Quick Start Guide for instructions on installing the software on the Measurement Computing Data
Acquisition Software CD. This booklet is available in PDF at www.mccdaq.com/PDFmanuals/DAQ-Software-
Quick-Start.pdf.
Installing the PCI-CTR10
The PCI-CTR10 board is completely plug-and-play, with no switches or jumpers to set. Configuration is
controlled by your system's BIOS. To install your board, follow the steps below.
Install the MCC DAQ software before you install your board
The driver needed to run your board is installed with the MCC DAQ software. Therefore, you need to install the
MCC DAQ software before you install your board. Refer to the Quick Start Guide for instructions on installing
the software.
1.
2.
3.
Turn your computer off, open it up, and locate two adjacent PCI expansion slots.
From the rear of the computer, place the PCI-CTR10 in the left hand of the two empty slots, so that the
empty slot is on the component side of the PCI-CTR10. Cabling is easier when there is an empty slot on the
component side of the board.
Close your computer and turn it on.
If you are using an operating system with support for plug-and-play (such as Windows 2000 or
Windows XP), a dialog box opens as the system loads, indicating that new hardware has been detected. If
the information file for this board is not already loaded onto your PC, you are prompted for the disk
containing this file. The Measurement Computing Data Acquisition Software CD supplied with your board
contains this file. If required, insert the disk or CD and click
OK.
To test your installation and configure your board, run the InstaCal utility you installed in the previous section.
Refer to the Quick Start Guide that came with your board for information on how to initially set up and load
InstaCal.
2-2
- PCI-CTR10 2
- HM PCI-CTR10.doc 3
- Table of Contents 5
- About this User's Guide 6
- Introducing the PCI-CTR10 7
- PCI-CTR10 block diagram 8
- Unpacking the PCI-CTR10 10
- Installing the software 10
- Installing the PCI-CTR10 10
- Pinout – main I/O connector 11
- The red stripe 12
- Programming languages 13
- Register-level programming 13
- Specifications 14
- Digital input / output 15
- 0 to 55°C 16
- -20 to 70°C 16
- 0 to 90% non-condensing 16
- Main connector and pin out 17
- Declaration of Conformity 18
Související produkty a manuály pro Hardware Measurement-computing PCI-CTR10
(20 stránky)Microlab SOLO4C manuals
Owner’s manuals and user’s guides for Loudspeakers Microlab SOLO4C.
We providing 1 pdf manuals Microlab SOLO4C for download free by document types: Datasheet
Komentáře k této Příručce