Measurement-computing 6K-SSR-RACK08 Uživatelský manuál stáhnout pdf (Strana 19)

6K-SSR-RACK08 User's Guide Installing the 6K-SSR-RACK08

3. Run the power cable out the back of the computer through an expansion slot or other opening, and replace

the cover on the computer.

Caution! Be careful not to pinch the cable when you replace the cover — if this cable is cut, the resulting

short circuit can damage the computer.

Connect the other end of the power cord to the connector labeled

PC POWER connector (P14) on the 6K-

SSR-RACK08. Refer to for the location of this connector. Figure 2-4

Figure 2-4

Set the POWER IN jumper (JP1) for +5PC.

External +9V AC adapter power connection

You can power the 6K-SSR-RACK08 using the AC power adapter (part number CB-PWR-9). This adapter

provides 9 volts, 1 amp DC power, 110 VAC power. To connect the AC adapter, do the following:

Turn off power to the computer.

Connect the CB-PWR-9 cable to the

9V EXTERNAL POWER connector (P13) on the 6K-SSR-RACK08.

Refer to for the location of this connector.

Plug the AC adapter into a power outlet.

Set the

POWER IN jumper (JP1) for 9V EXT.

I/O type

Set the type for each module group for either input or output (default). You cannot mix the I/O configuration

within a group.

 Jumper

JP2 sets the I/O type for SSR modules 1-4

 Jumper

JP3 set the I/O type for SSR modules 5-8.

Refer to for the location of these jumpers. shows the SSR modules 1-4 configured for

input (jumper position 2-3), and SSR modules 5-8 configured for output (jumper position 1-2).

Figure 2-6

Figure 2-6. I/O module type jumpers

JP2

OUT

JP3

OUT

SSR modules 1-4

configured for input

SSR modules 5-8

configured for output

Relay logic

Set the relay logic for each module group to be either inverted (active high) or non-inverted (active low,

default). Jumper

JP5 sets the logic for SSR modules 1 to 4. Jumper JP6 sets the relay logic for SSR modules 5

to 8. The logic settings are labeled

INVERT and NON-INVERT on the board.

 When you set the logic jumper to NON-INVERT, the SSR modules activate when the digital output signal

is low.

 When you set the logic jumper to INVERT, the SSR modules activate when the digital output signal is

high.

2-10

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 32 33

Komentáře k této Příručce

Žádné komentáře

Measurement-computing 6K-SSR-RACK08 Uživatelský manuál Strana 19

Komentáře k této Příručce

Související produkty a manuály pro Hardware Measurement-computing 6K-SSR-RACK08