Measurement-computing STLITE-CPCI-xxx Uživatelský manuál

STLITE-CPCI-8R(+)STLITE-CPCI-16R(+)Satellite SeriesCPCI Expansion SystemUser’s Manual Copyright February, 2001

6either Bus 3 or 4. Thus, the first PPB in the second expansion rack will have its primary attached to Bus 3 or 4its secondary will be motherboard’s B

75.3 FAN-OUT CONFIGURATIONIn this configuration, the Host Bridge card for a second CPCI chassis is inserted in an open slot in the firstexpansion rac

85.4 EXTENDED DAISY CHAIN CONFIGURATIONIf, rather than attaching the third expansion chassis to Bus 2, we had attached it to Bus 6 (in the secondexpa

96. SATELLITE MONITOR SOFTWARE INSTALLATION AND USEIncluded with the Satellite expansion chassis is the Satellite Parametric Monitor Application for m

10Figure 6-3. Window Menu Figure 6-4. View MenuFigure 6-5. Format MenuView MenuFigure 6-6. Format Menu > Scale AxesEach Satellite device is

11To add or remove traces from the strip charts, select the Data Sources item under the Format menu, and select ordeselect the checkboxes correspondin

12The watchdog timer period is set via a jumper. The default position of 30 seconds is shown above. Table 6-1below describes the W/D timer settings as

137. REGISTER MAP7.1 REGISTER MAPThe STLITE -CPCI-8R/16R provides two sets of general-purpose I/O bits (GPIO0-GPIO3). The first set ofGPIO control bi

14GPIO IN Register (0x67 offset of PCI Header) Read OnlyD7 D6 D5 D4 D3 D2 D1 D0X SDO X X RESERVED RESERVED RESERVED RESERVEDGPIO3 GPIO2 GPIO1 GPIO0Th

158. SPECIFICATIONSSTLITE-PCI-HOST, STLITE-CPCI-HOSTTypical for 25°C unless otherwise specified.Power consumption+5V 375 mA maxFeaturesBridge Industr

iiLIFETIME WARRANTYEvery hardware product manufactured by Measurement Computing Corp. is warranted against defects inmaterials or workmanship for the

16HOST BRIDGE CONNECTOR PIN OUTPin Signal Name Pin Signal Name1 GND 41 HST_S_AD002 HST_5V 42 HST_S_AD013 GND 43 HST_S_AD024 PWR_MON 44 HST_S_AD035 GND

17STLITE-CPCI-16R, STLITE-CPCI-16R+, STLITE-CPCI-8R, , STLITE-CPCI-8R+Typical for 25°C unless otherwise specified.FeaturesSlots STLITE-CPCI-16Rx: Six

18System MonitoringSystem monitoring features are accessed via VB/C++ example programs and DLL provided with the product.A/D Converter TLV2548, 8-chan

19CHASSIS BRIDGE CONNECTOR PIN OUTPin Signal Name Pin Signal Name1 GND 41 HST_AD002 PWR_MON 42 HST_AD013 GND 43 HST_AD024 TRGT_5V 44 HST_AD035 GND 45

20For Your Notes

EC Declaration of ConformityWe, Measurement Computing Corp., declare under sole responsibility that the product:STLITE-CPCI-8RSTLITE-CPCI-16RCPCI BUS

Measurement Computing Corporation16 Commerce Boulevard,Middleboro, MA 02346(508) 946-5100Fax: (508) 946-9500E-mail: [email protected].

iiiTable of Contents1. INTRODUCTION...

iv7.3 SATELLITE HOST BOARD 21150 BRIDGE REGISTERS ...148. SPECIFICATIONS...

11. INTRODUCTIONThe STLITE-CPCI-8R(+) and -16R(+) are expansion chassis having either eight or sixteen slots for expandingthe Compact Peripheral Compo

22. COMPONENTS – STANDARD SYSTEMThe STLITE-CPCI-16R (Figure 2-1) consists of the following major components:Figure 2-1. STLITE-CPCI-16R2.1 CPCI EXPA

32.4 EXPANSION CABLEThe STLITE-CPCI-8R/16R is supplied with a STLITE-C-3 cable. This is a shielded three-foot cable forconnecting the host bridge car

43.4 CPCI EXPANSION CABLE INSTALLATION1. Position the chassis within easy reach of the three-foot cable.2. Attach the cable to the Host Bridge card

54. POWERING-UP4.1 SEQUENCE FOR APPLYING POWERIt is important that higher-numbered PCI buses in your system’s hierarchy be powered-up and in a stabl